Reply To: RE: Getting an error updating from 2.1.1-1 to 2.3.0.-2

VitalPBX Community Support General Discussion Getting an error updating from 2.1.1-1 to 2.3.0.-2 Reply To: RE: Getting an error updating from 2.1.1-1 to 2.3.0.-2

    Posted by: DannyLarsen

    I moved my backup to a fresh server and it solved the issue with the CDR not showing up

    However I now see that I cannot save any changes in the System/Misc section

    Such as Time, Notification and Storage

    This issue shows up on the fresh server install and the updated server

    About this issue, I just tried in a clean installation but the only thing that I noticed was that I can’t update the time zone when the NTP is enabled. However, if you disable the NTP, you may update the timezone.

    I didn’t see any other issue on this module.

    0