cant dial from a tenant extension to another

VitalPBX Community Support General Discussion cant dial from a tenant extension to another

  • Post
    vitorcosta
    Participant

    After create a new tenant and add 3 extensions (1001, 1002 and 1003). I configure each extension on a device (ip phone and softphone), but when dial from extension 1002 to 1001 get a message: BLOKED   log show sometihing like COS_ALL not Allowed… Print screen attached  

    0
Viewing 9 replies - 1 through 9 (of 9 total)
  • Replies
    Up
    0
    Down

    Go to the Linux console and execute the following command:

    vitalpbx --fully-dump-conf
    0
    vitorcosta
    Participant
    Up
    0
    Down

    @ing-joserivera26

    Done and solved the problem. 

    Need do it for each new tenant created ? or do it time to time ?

     

    0
    Up
    0
    Down

    Maybe this is an issue. We will check the Multi-Tenant module and try to find the reason that sometimes doesn’t generate the full Asterisk Database when creating a new tenant.

    0
    vitorcosta
    Participant
    Up
    0
    Down

    I created a new Tenant and same issue happens. Run command again and all work. So , seens like each new Tenant need this command to work…A fix will be very important as i see…

    0
    Up
    0
    Down

    We already found the issue, Thanks for reporting it

    0
    Up
    0
    Down

    This issue has been already fixed up in version 2.3.6 of VitalPBX

    0
    vitorcosta
    Participant
    Up
    0
    Down

    Occour again after upgrade to 3.6..

    0
    Up
    0
    Down

    How can I reproduce the issue you are reporting? because testing by myself all is working as expected.

    0
    vitorcosta
    Participant
    Up
    0
    Down

    Ok. Next Tenant i need create i will test it again

    0
Viewing 9 replies - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.