GOIP GSM GATEWAY

› VitalPBX Community Support › General Discussion › GOIP GSM GATEWAY

  • Post
    • April 7, 2020 at 4:10 am
    khairidz
    Participant

    Hi, I recently installed VitalPBX on my AWS and its working great!

    I am trying to configure my GOIP GSM Gateway to my VitalPBX using Dynamic SIP Registration.

    The GSM Gateways are running on dynamic IP remotely.

    I created a trunk using text mode with the following Peer Parameters;

    [GOIP]
    defaultuser=GOIP
    type=peer
    secret=****
    qualify=yes
    nat=force_rport,comedia
    insecure=port,invite
    host=dynamic
    dtmfmode=inband
    disallow=all
    canreinvite=yes
    call-limit=2
    allow=alaw
    allow=ulaw

    I was not able to register my GOIP using these credentials.

    I was able to register this SIP account in my soft-phone.

    I was able to register my GOIP using the same format in FreePBX.

    Any advice or suggestions?

    Thank you!
    Stay Safe!

    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • Replies
    • April 7, 2020 at 4:57 am
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    You must change the host with the IP of the GOIP GSM gateway.

    0
    • April 7, 2020 at 5:28 am
    khairidz
    Participant
    Up
    0
    Down

    Hi Mrivera, thank you for your reply.

    I think you mis understood my post. GOIP GSM Gateway is running on dynamic public IP.

    I will register GOIP GSM Gateway (Public Dynamic IP) to VITALPBX (Public Static IP).

     

    0
    • April 7, 2020 at 3:37 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    You should check the asterisk log or use the SNGREP to see what is happening when the GOIP GSM try to connect against VitalPBX

    0
    • April 9, 2020 at 11:46 pm
    khairidz
    Participant
    Up
    0
    Down

    Hi Mrivera, Thank you. Registration using dynamic registration is working perfectly now. 

    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.