Help creating trunk with outbound Proxy

› VitalPBX Community Support › General Discussion › Help creating trunk with outbound Proxy

  • Post
    • December 13, 2019 at 7:34 pm
    vitorcosta
    Participant
    Up
    0
    Down

    We need to configure a new trunk, but the provider uses an outbound proxy, we can configure and use the SIP account in a Yealink Phone, In MicroSip, Zoiper, etc… But in the Vital, cant make it register, we cant add the outbound proxy information.

    0
Viewing 9 replies - 1 through 9 (of 9 total)
  • Replies
    • December 13, 2019 at 7:41 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    What kind of trunk are you using on VitalPBX?

    0
    • December 13, 2019 at 7:47 pm
    vitorcosta
    Participant
    Up
    0
    Down

    A standard SIP Trunk, there is an image with the data used in the Micro SIP Softphone.
    Here a Zoiper example

    0
    • December 13, 2019 at 7:54 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    Are you using Plain Mode? or Visual Mode?

    If you are using the Visual Mode, go to the advanced tab and in the custom settings sections place on the parameter field “outboundproxy”, and, in the value field “YOUR_IP_PROXY”.

    If you are using the Plain Text Mode, just put in your trunk definition this:

    outboundproxy=YOUR_IP_PROXY

    0
    • December 13, 2019 at 8:02 pm
    vitorcosta
    Participant
    Up
    0
    Down

    @ing-joserivera26

    Tryed both ways.
    Anyway, I cant receive calls, because the register doesnt occur.
    With the CLI Command sip show peer the trunks appears OK, but if I try sip show registry, it isnt registered.
    Tryed to use some options like type=friend, autocreatepeer, callbackexten but none of them appears to work for receiving calls.

    0
    • December 13, 2019 at 8:06 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    On SIP Settings add this custom parameter:

    supportpath=yes

    0
    • December 13, 2019 at 8:32 pm
    vitorcosta
    Participant
    Up
    0
    Down

    @ing-joserivera26

    Added, but keeps the same. The registry shows only request sent, looks like the outboundproxy option works fine for the “peer” section, but no effect in the registry.

    0
    • December 13, 2019 at 10:41 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    What is your register string? you may try:

    register => USERNAME:PASSWORD:USERNAME@TRUNK_NAME/YOUR_DID_NUMBER
    0
    • December 14, 2019 at 6:31 pm
    vitorcosta
    Participant
    Up
    0
    Down

    Problem solved  simple using  this register string format:

    romuser@fromdomain:secret:authuser@host:port/extension

     

    0
    • December 16, 2019 at 5:53 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    Thanks for share

    0
Viewing 9 replies - 1 through 9 (of 9 total)
  • The topic ‘Help creating trunk with outbound Proxy’ is closed to new replies.