Help! how to set inbound did dailing?

› VitalPBX Community Support › General Discussion › Help! how to set inbound did dailing?

Up
0
Down
  • Post
    • March 6, 2019 at 3:56 am
    Up
    0
    Down
    netsfish
    Participant

    I have a VitalPBX(192.168.0.81,stn=5001) & a FreePBX(192.168.0.68,stn=6000),

    now 5001 can dail to 6000 and it connected,

    but 6000 can not dail 5001

    How to set did incoming in ViatlPBX?

     

    messages:

    543 23.347370543 192.168.0.81 -> 192.168.0.68 SIP 589 Status: 100 Trying |
    575 23.352613007 192.168.0.68 -> 192.168.0.81 SIP 436 Request: ACK sip:5001@192.168.0.81:5060 |
    807 25.481205774 192.168.0.68 -> 192.168.0.81 SIP 460 Request: BYE sip:5001@192.168.0.81:5060 |
    809 25.481523792 192.168.0.81 -> 192.168.0.68 SIP 521 Status: 200 OK |

    0
Viewing 5 replies - 1 through 5 (of 5 total)
  • Replies
    • March 6, 2019 at 4:10 am
    Up
    0
    Down
    oromero31
    Participant

    Witch class of services is set at the sip trunk?? 

    0
    • March 6, 2019 at 4:11 am
    Up
    0
    Down
    oromero31
    Participant

    Try to set all permission.

    0
    • March 6, 2019 at 6:23 am
    Up
    0
    Down
    netsfish
    Participant

    Yes,you are right! I set cos to all permission,and it can be called now! 

    Thank you so much!

     

    ?

    0
    • March 6, 2019 at 7:16 am
    Up
    0
    Down
    netsfish
    Participant

    Hi,Now i have a new question,can you help me?

    ViatlPbx has a stn(5001),it ‘s a internal number.when 5001 call outside the VitalPBX,i set the CID number is 58885001. Then external PBX screen the calling number is 58855001.

    But when External PBX  make the call to VitalPBX,Always send the Callednumber 58885001 to VitalPBX, my question is :My extension number is 5001, how can i remove the 5888? i can not find where to config the “remove”or”replace”.

    Dou you know?

    thank you~!

     

    0
    • March 6, 2019 at 6:25 pm
    Up
    0
    Down
    Jose Miguel Rivera
    Keymaster
    NI

    I recommend you to use the default trunk context (class of service) always, and add multiple DID for your extensions

    0
Viewing 5 replies - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.