High Availability Setup

VitalPBX Community Support General Discussion High Availability Setup

  • Post
    JohannS
    Participant
    Up
    1
    Down
    Good day all.

    I’ve gone through the latest HA setup guide (the one in Github), and everything went well, had no errors in the setup.

    But now, everything is done and the services aren’t started….

    Running “role” gives me this:

    Role : Standby
    Version : 3.0.6-2
    Asterisk : 18.1.1
    Linux Version : CentOS Linux release 7.9.2009 (Core)
    Welcome to : ha01-master.local
    Uptime : 9:43
    Load : Last Minute: 0.34, Last 5 Minutes: 0.09, Last 15 Minutes: 0.07
    Users : 2 users
    IP Address : 10.200.248.110
    Clock : Fri 2021-03-05 08:35:00 SAST
    NTP Sync. : no

    ************************************************************
    * Servers Status *
    ************************************************************
    Master
    virtual_ip (ocf::heartbeat:IPaddr2): Stopped
    asterisk (service:asterisk): Stopped
    lsyncd (service:lsyncd.service): Stopped

    Servers Status
    ha01-111.local: Online
    ha01-110.local: Online
    [root@ha01-master ~]#

    the only change between the master and slave when running “role” is that the hostname changes, so it says “Welcome to : ha01-slave.local” but everything else stays the same.

    What can I look at, what debugging can I do to get good info to troubleshoot with??

     

    Best Regards

    JohannS

     

    0
Viewing 1 replies (of 1 total)
  • Replies
    Rodrigo Cuadra
    Keymaster
    US
    Up
    0
    Down
    Are the two servers on the same lan network?
    Are you sure that the servers can access each other without the need to authenticate?
    0
Viewing 1 replies (of 1 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.