How to set about the VitalPBX inbound DID calls? Help -_-

› VitalPBX Community Support › General Discussion › How to set about the VitalPBX inbound DID calls? Help -_-

  • Post
    • March 5, 2019 at 9:17 am
    netsfish
    Participant

    I am a beginner，Now I have finish the installation of VitalPBX. I’m do the testing.Now i have a problem,I have a VitalPBX and a FreePBX(also other SoftSwitch),and i had make the sip trunk to each other.VitalPBX’s stn(5001) can make the call to FreePBX stn(6000),but Freebpx(6000) can not call the VitalPBX 5001. seams sad ” all circuit busy now”.  

    I am think about the setting about the “inbound Routes”,if i set the inboundroute->Inbound Destation->to a station(5002),then it connected!,i want to know if i want make the DID calls from the external endpoint,how to set the inbound Routes? I can not find the paramaters about the DID incoming calls….

     

     

    0
Viewing 5 replies - 1 through 5 (of 5 total)
  • Replies
    • March 5, 2019 at 9:57 am
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    May you share a call log when call is rejected?

    0
    • March 5, 2019 at 10:33 am
    netsfish
    Participant
    Up
    0
    Down

    I find the problem! FreePBX ‘s Problem.now it’s worked! Thank you!

    0
    • March 5, 2019 at 10:54 am
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    May you share your solution? This may help other users. Thanks

    0
    • March 6, 2019 at 3:46 am
    netsfish
    Participant
    Up
    0
    Down

    there is something wrong,it’s wroked because i set the inbound destation to 5001, so all calls form other trunk called to 5001.

    i still on find how to set the DID incoming… ? 

    0
    • March 6, 2019 at 7:20 am
    netsfish
    Participant
    Up
    0
    Down

    Now it’s ok

    In class of services of sip trunk,the COS should be set all permissons.

    0
Viewing 5 replies - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.