https no longer works only http after upgrade

VitalPBX Community Support General Discussion https no longer works only http after upgrade

  • Post
    Steve
    Participant
    System Information
    Distro CentOS Linux release 7.7.1908 (Core)
    Kernel 3.10.0-1062.4.1.el7.x86_64
    Asterisk 16.6.0
    VitalPBX 2.3.8-3
    Last boot Thu, 31 Oct 2019 06:25:31 -0400

    After upgrade, I noticed I couldn’t login any longer iwth https, I had to use http.  It was working fine before the upgrade.

     

    Any help would be appreciated.

    TIA.

    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • Replies
    Up
    0
    Down

    I assume you’re installation didn’t finish. We have tested updating our demo PBX and doesn’t presents any issue.

    0
    Steve
    Participant
    Up
    0
    Down

    No it took a little while but it completed.

    0
    Steve
    Participant
    Up
    0
    Down

    I set the cert to native, saved then changed back to letsencrypt twice and now it seems to be working as 443 (httpd)

     

    0
    Up
    0
    Down

    After updating the PBX if you start experiencing some kind of problems, you may execute the following command:

    vitalpbx –dump-conf   # Generate the configurations for the main tenant only

    vitalpbx –fully-dump-conf # Generate the configurations for all the tenants

    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • The topic ‘https no longer works only http after upgrade’ is closed to new replies.