Outbound priority

› VitalPBX Community Support › General Discussion › Outbound priority

  • Post
    • June 9, 2020 at 4:21 am
    rudolfl
    Participant
    Up
    0
    Down
    ::
    Hi all,

    If I have two SIP trunks for outbound calls, how can i specify that one of them is to be used for all outbound calls and second one only as a fallover if primary one is in use?

     

    Thanks,

    Rudolf

    0
Viewing 3 replies - 1 through 3 (of 3 total)
  • Replies
    • April 3, 2021 at 7:27 am
    briansmith84
    Participant
    none
    Up
    0
    Down
    ::
    Hey, did you ever figure this out?
    0
    • April 5, 2021 at 3:16 am
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down
    ::
    Remember that in the outbound routes you can select more than one trunk, and all of them will be called according to the defined order.

    Check the attached screenshot.

    Attachments:
    You must be logged in to view attached files.
    0
    • April 12, 2021 at 12:11 pm
    PitzKey
    Participant
    US
    Up
    0
    Down
    ::
    Additionally, you can also set a outbound route sequence in COS.
    0
Viewing 3 replies - 1 through 3 (of 3 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.