Outgoing calls hang up after a few seconds of ringing

› VitalPBX Community Support › General Discussion › Outgoing calls hang up after a few seconds of ringing

  • Post
    • August 10, 2018 at 7:29 am
    tonywhelan
    Participant
    Up
    0
    Down
    ::

    VitalPBX 2.0.4-4

    An unusual thing has started happening recently. When I call a mobile phone number, I get a couple of bursts of ring tone, then the call disconnects altogether.

    The log shows a line stating ” app_dial.c: Nobody picked up in 10000 ms”

    This happens no matter which of the three SIP provider trunks I use to initiate the call.

    I’m unable (so far) to find a setting that would explain why this is happening.

    Any ideas would be welcome.

    PS I rebooted the PBX just in case that helped, but it didn’t.

    0
Viewing 1 replies (of 1 total)
  • Replies
    • August 10, 2018 at 8:04 am
    tonywhelan
    Participant
    Up
    0
    Down
    ::

    Ah, just found the setting “Ring time” in Trunks, was set to 10 seconds. Not sure why, but I guess I fiddled with it some time ago. Dopey me.

    0
Viewing 1 replies (of 1 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.