Round robin on trunks

› VitalPBX Community Support › General Discussion › Round robin on trunks

  • Post
    • September 22, 2018 at 5:33 am
    pdifeo
    Participant
    Up
    0
    Down

    Hi,

    it’s possible use on a outbound route specify more than a trunk. But if I want use them in round robin and not in failover mode, is it possible ?

    Thanks

    0
Viewing 2 replies - 1 through 2 (of 2 total)
  • Replies
    • September 22, 2018 at 2:07 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    You can use failover trunks, but in a particular order.

    There’s not way to set trunks or outbound routes in round robin order

    0
    • September 22, 2018 at 5:33 pm
    pdifeo
    Participant
    Up
    0
    Down

    Too bad it can’t be done. I have two prepaid trunks. It would have been useful if outgoing calls had used the two trunks alternately.

    0
Viewing 2 replies - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.