Telnyx trunk configuration by IP

› VitalPBX Community Support › General Discussion › Telnyx trunk configuration by IP

  • Post
    • April 2, 2019 at 5:40 pm
    kbohannon
    Participant
    Up
    0
    Down

    I’ve been using Telnyx for a few years and quality has been stellar. Due to a problem with using the credentials method with Kerio Operator (Operator frequently reported connections as being down) I switched to the IP method. I read the support article about configuring Telnyx trunks using credentials; anything to note if I wanted to keep the IP method?

    Kerry Bohannon
    Amicus Voice, LLC

    0
Viewing 3 replies - 1 through 3 (of 3 total)
  • Replies
    • April 6, 2019 at 2:54 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    Did you already try to use the IP method? If you did it, what were the results? 

    0
    • April 6, 2019 at 3:05 pm
    kbohannon
    Participant
    Up
    0
    Down

    I did. No problems at all. But the trunk’s configuration requires an outgoing username. I have just been putting in the hostname. Better if the field weren’t required.

    Kerry Bohannon
    Amicus Voice, LLC

    0
    • April 6, 2019 at 3:08 pm
    Jose Miguel Rivera
    Keymaster
    NI
    Up
    0
    Down

    The outgoing username is just the device or username used for your trunk

    [device_name] ;here goes the outgoing username

    maybe the label is not the best.

    0
Viewing 3 replies - 1 through 3 (of 3 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.