voip innovations setup for multi-tenant

VitalPBX Community Support General Discussion voip innovations setup for multi-tenant

  • Post
    syadnom
    Participant
    Up
    0
    Down
    I’m new, just demoing out the system for multi-tenant use.  Anyone run VoIP Innovations in a multi-tenant setup?  Wondering how to actually configure this because trunks are per tenant.  Thanks in advance
    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • Replies
    Cristian Rojas
    Keymaster
    none
    Up
    1
    Down
    Do you have any diagram of your tenants-servers environment?
    0
    syadnom
    Participant
    Up
    0
    Down
    Do you have any diagram of your tenants-servers environment?

    I have nothing built, this is a scratch start.

    0
    Cristian Rojas
    Keymaster
    none
    Up
    0
    Down
    About the trunks per tenant, every single tenant can configure their own trunks for their outbound routes. 
    The objective of this architecture is that the tenant can have total freedom of configuration in their own environment.
    The main user can set some configuration if necessary and these can be related to tenants and trunks. 
    0
    syadnom
    Participant
    Up
    0
    Down
    VoIP Innovations is IP based auth, so It’s going to send all calls to the host’s IP address.  This is what I need to know how to handle.  Do I just put identical trunks in each tenant for VoIP Innovations and then put the DIDs in each tenant?
    0
Viewing 4 replies - 1 through 4 (of 4 total)
  • The forum ‘General Discussion’ is closed to new topics and replies.