microvb

Forum Replies Created

Viewing 3 replies - 1 through 3 (of 3 total)
  • Replies
  • microvb
    Participant
    Up
    0
    Down
    ::

    I mentioned the flow in the original post as follows :

    1. Caller calls a specific number on the switch.
    2. Switch looks up callers caller id in database. If not listed, switch aborts the call with a Not In Service tone (or other tone that indicates the line is dead/inaccessible)
    3.  If listed in the database, switch then plays a dialtone or greeting, and allows caller to enter digits.
    4.  Digits are checked against a number plan, and if valid – call is routed to that number using the trunk assigned to that number plan.

    The feature you have in place that comes close, requires a PIN as mentioned when I first requested this. The request is to have the option to use Caller ID and a lookup-table in place of a PIN on that feature.

    0
    microvb
    Participant
    Up
    0
    Down
    ::

    Could you please provide an update on this ?

    0
    microvb
    Participant
    Up
    0
    Down
    ::

    Could you please look into the possibility of opening things up like config, and templates as open ?

    0
Viewing 3 replies - 1 through 3 (of 3 total)